5-7. Feeder Set Up Push Button
3
4
Sequence
5
Trigger Control
Trigger Hold
1
Feeder Set Up
| Start | Weld | Crater | ||
| Time | ||||
| Time | Time | |||
|
| ||||
2 | Preflow |
|
|
| |
|
| Postflow | |||
| Time |
| |||
|
| Time | |||
|
|
|
| ||
6 |
|
|
|
|
|
|
|
|
|
| |
|
|
|
| ||
| Welding Sequence Diagram | ||||
1Feeder Set Up Push Button
2Feeder Set Up Push Button LED
Press button to choose sequence, trigger control, or trigger hold.
3Sequence LED
4Trigger Control LED
5Trigger Hold LED
6Lock LED (Access Allowed Only By Using An Optional PDA With File Management Software)
•When the Feeder Set Up button is pressed while in standby, the Feeder Set Up push button LED illuminates and the top display will be active. Use the Adjust control to select preflow (PRE), start (STRT), crater (CRTR), or postflow (POST) parameters.
•Press the lower display push button to allow the bottom display to become active. The time LED will automatically begin flashing
and the unit will be in the time mode. Initially, all sequences will appear as off. Use the Adjust control display time and enable the time sequence. Setting a time automatically enables a sequence. To turn off a sequence, change time setting to OFF.
•If the sequence has a voltage or arc adjust setting, pressing the lower display push button a second time will cause either volts or arc adjust to appear on the display. Use the Adjust control to set either parameter.
•If the sequence has a wire feed setting, pressing the lower display push button a third time will cause wfs to appear on the display. Use the Adjust control to set wire speed parameter.
•Press the lower display push button a fourth time will cycle the display back to time.
•Press the Feeder Set Up button a second time to go to Trigger Control mode and allow
the top display to become active. Use the Adjust control to cycle through trigger control methods as follows: dual schedule, trigger hold, trigger dual schedule, program select, 4T (see Section
•Press the lower display push button to allow the bottom display to become active. Use the Adjust control to turn selected trigger control methods on or off. If trigger hold is set to on, the trigger hold LED will illuminate. Note: if 4T is set to on, trigger hold will automatically be set to on since this parameter is necessary for the 4T function.
•Press the Feeder Set Up button a third time to cycle back to standby mode.
5-8. Adjust Control
| 1 Adjust Control |
| The Adjust control is used to |
| change various sequence parame- |
| ters, and to select various se- |
| quences. Refer to the section for |
| the function in question for informa- |
1 | tion related to using the Adjust con- |
trol. |
Adjust
