Miller Electric 75 manual Setting Sequence Parameters, Sequence Parameters In a Program

SECTION 6 − SETTING SEQUENCE PARAMETERS

6-1. Sequence Parameters In A Program

	Sequence		Parameters
		Volts/Trim	IPM	Seconds
1.	Preflow			Off-5.0
2.	Postflow			Off-5.0
3.	Start	10.0-44.0/	40-1400/	Off-5.0
		0-99	0-99
4.	Crater	10.0-44.0/	40-1400/	Off-5.0
		0-99	0-99

.For more information on

Sequence mode, see Feeder Set Up Push Button in Section 5-7.

If time is set to Off in Weld sequence, welding continues until gun trigger is released.

If time is set to zero in any timed sequence except Weld, the sequence is skipped.

.Maximum IPM may actually

be lower depending on wire size and gas combination.

X = Setting available.

				Weld
				Crater
				Time
		Start
	Preflow	Time			Postflow
	Time				Time
						Time
Preflow		Start	Weld	Crater	Postflow	Sequence
						End
Trigger				Trigger
Pressed				Released

OM-228 956 Page 27