Miller Electric APT-1000 manual Operating the Torch

B. Installing Torch In Inverter Power Source

Label is located under terminal strip.

6	1	2	3	4
				S-137 691

5

7

8

9

Tools Needed:

5/8 in

Turn Off power source, and disconnect input power plug. Open lower front access door.

			1	Access Door
			2	Strain Relief Clamp
			3	Torch Cable
			4	Torch (–) And Air/Gas Output
				Connector
			Connect torch cable as shown.
			5	Terminal Strip1T
1	4		6	Connection Label
			7	Pilot Arc/Shield Cup Detector
				Lead 1
			8	Shield Cup Detector Lead 2
			9	Torch Switch Leads 3 And 4
			Refer to label and connect leads as
			shown.
			Install strain relief clamp, and close
		3	access door.
2			10	Work Cable (Supplied With

Power Source)

10

ST-128 701-C

Figure 3-3. Installing Torch In Inverter Power Source

SECTION 4 – OPERATING THE TORCH

WARNING

ELECTRIC SHOCK can kill.		ARC RAYS can burn eyes and skin;
•	Always wear dry insulating gloves.	NOISE can damage hearing.
•	Insulate yourself from work and ground.	•	Wear face protection with correct shade of filter.
•	Do not touch live electrical parts.	•	Wear correct eye, ear, and body protection.
•
	Keep all panels and covers securely in place.	MOVING PARTS can cause injury.
		•	Keep away from moving parts.
FUMES AND GASES can be hazardous
		• Keep all doors, panels, covers, and guards closed
to your health.
•	Keep your head out of the fumes.		and securely in place.
•	Ventilate area, or use breathing device.	See Safety Precautions at beginning of manual for ba-
•	Read Material Safety Data Sheets (MSDSs) and	sic cutting safety information.
	manufacturer’s instructions for material cut.

CUTTING can cause fire or explosion.

• Do not cut near flammable material.
•	Provide protection from flying sparks.
•	Watch for fire; keep extinguisher nearby.
•	Do not locate unit over combustible surfaces.
•	Do not cut on closed containers.
•	Allow work and equipment to cool before handling.	swarn6.1* 10/91

OM-1572 Page 4