Figure 5-2. Checking Detector Pins And Checking/Replacing Shield Cup, Tip, And Electrode
5-3. Troubleshooting
WARNING |
ELECTRIC SHOCK can kill. | HOT PARTS can cause severe burns. |
• Do not touch live electrical parts. | • Allow cooling period before maintaining or servicing. |
•Turn Off power source, and disconnect input power
before inspecting, maintaining, or servicing.
Troubleshooting to be performed only by qualified persons.
swarn8.1* 2/93
Table 5-1. Cutting Trouble
Trouble | Remedy |
Section
Sparks come out top of cut, or cut is not clean.
Arc goes out while cutting.
Arc goes on and off while cutting.
Torch travel speed too fast; reduce travel speed.
Check torch tip and electrode, and replace if necessary.
Metal being cut is too thick; increase power source Thickness control setting.
Make sure torch tip is touching metal while cutting.
Be sure work clamp is securely attached.
Torch travel speed is too slow; increase travel speed. Check torch tip and electrode, and replace if necessary.
Figure
*
Figure
*
Figure
*See power source Owner’s Manual.
