Miller Electric XMC 4000 Weld Output Terminals And Selecting Cable Sizes, 120 m, Ground connector

3-5. Weld Output Terminals And Selecting Cable Sizes

Y ARC WELDING can cause Electromagnetic Interference.

To reduce possible interference, keep weld cables as short as possible, close together, and down low, such as on the floor. Locate welding operation 100 meters from any sensitive electronic equipment. Be sure this welding machine is installed and grounded according to this manual. If interference still occurs, the user must take extra measures such as moving the welding machine, using shielded cables, using line filters, or shielding the work area.

			Total Cable (Copper) Length In Weld Circuit Not Exceeding
		30 m Or Less		45 m	60 m	70 m	90 m	105 m	120 m
	Welding	10 − 60%	60 − 100%
Weld Output Terminals		Duty	Duty		10 − 100% Duty Cycle
	Amperes
		Cycle	Cycle
	100	20	20	20	30	35	50	60	60
	150	30	30	35	50	60	70	95	95
MIG connector	200	30	35	50	60	70	95	120	120
	250	35	50	60	70	95	120	2//70	2//70
	300	50	60	70	95	120	2//70	2//95	2//95
	350	60	70	95	120	2//70	2//95	2//95	2//120
Ground connector	400	60	70	95	120	2//70	2//95	2//120	2//120
	500	70	95	120	2//70	2//95	2//120	3//95	3//95
	600	95	120	2//70	2//95	2//120	3//95	3//120	3//120

// means 2 cables with the same section in parallel.

3-6. Remote 7 Receptacle Information
	Socket	Socket Information
	1	+10 volts dc supply voltage to remote
	2	GND Remote control circuit common
	3	IREF 0 to 10 current control signal
	4	VREF 0 to 10 voltage control signal
	5	UP 0V/10V digital signal
	6	DOWN 0V/10V digital signal
Remote 7	7	TYPE 0V/10V digital signal

Note: This remote receptacle cannot be used with a standard Miller remote control. A customer supplied remote control is required to use the remote receptacle.

OM-221 694 Page 12