Minicom Advanced Systems DX System 20. Updating the DX User and XRICCS/RICCs

1 72

DX SY

STEM

Figure 64 DXC update utility options

You can choose any of the following:

· Check version

· DX Central Settings (Check and/or change the settings)

· Update the DX Central firmware

· Restore factory defaults – and erase the current database

· Backup System (database)

· Restore System (by loading a saved database)

To do any of the above, check the desired option and click Next.

4. Under DX Central Settings, you can change the DX Central network settings or

IP address.

To update the firmware or load a saved database, locate the file and click Open.

To backup the database, save the current database to the Hard drive.

To restore factory defaults, press OK.

20. Updating the DX User and XRICCS/RICCs

From the DX AIM you can update the firmware for the:

· DX User unit

· XRICCs – PS/2, SUN and USB

· RICC PS/2

To obtain the latest firmware for your system go to www.minicom.com and look in

the Support section.

Contents

Main DX System User Guide Table of Contents Page Page Welcome 1. Introduction 2. Pre-installation guidelines Page USER GUIDE 8 3. DX system outline MINICOM Figure 1 DX system outline DX 832 3.2 DX User units Figure 4 illustrates the front panel of the DX User unit. DX User Figure 4 DX User front panel Page 4. Connecting the DX system Page 13 X-RICC RS232 X-RICC SUN DX Central X-RICC PS/2 CAT5 cables Up to 100M / 330ft To Server ports I 0 Page Page Page 5. Power management 6. Connecting Legacy KVM switches 7. Cascading DX Central units 19 0 Figure 16 Cascaded DX Central units connected with a Crossover cable The table below shows the Ethernet RJ 45 Connector pin-out. USER GUIDE Figure 17 Cascaded DX Central units connected to a hub/switch Figure 18 Configuration Wizard Page Page 8. Powering on the system 9. Configuration wizard (non-DX cascaded system) 10. Logging in 11. Configuring the DX system Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page 12. Creating/editing Users and Groups Page Page Page Page Page 13. Arranging devices Page Page Page Page 14. Scanning a group of servers 15. Adjusting the picture quality 16. Connect - Private 17. Disconnect User 18. Connecting to a local computer 19. Updating the DX Central Page Page 20. Updating the DX User and XRICCS/RICCs Page 21. Events log Page 22. Troubleshooting - Resetting the DX Central 23. USB / SUN Combo keys 24. Technical specifications System DX units 25. Terminal hotkeys