UNINET IMAGING INC. • MINOLTA® MAGICOLOR 5430 CARTRIDGE REMANUFACTURING INSTRUCTIONS
13.Separate the two halves by first pulling out the developer unit from where the pin was removed. Once it clears the waste hopper section pull the two halves apart away from each other as shown
DISASSEMBLING THE DRUM UNIT
14.Remove the OPC drive gear support by first releasing the screw that holds the support plate in place.
15.Once the screw has been removed, turn the support counter clockwise until it comes to a stop. This will unlock the support and allow you to remove it completely.
16.Final position of drive gear support plate that can now be removed.
w w w. unineti m a g i n g . c o m / t e c h n i c a l . a s p
11124 Washington Blvd., Culver City, California USA 90232 • Ph +1 310 280 9620 • Fx +1 310 280 0533 • techsupport2@uninetimaging.com
© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.
