UNINET IMAGING INC. • MINOLTA® MAGICOLOR 5430 CARTRIDGE REMANUFACTURING INSTRUCTIONS
REMOVING THE WIPER BLADE
21.Remove the wiper blade by first disengaging the two screws (shown) that hold it in place.
22. Remove the wiper blade in the manner shown.
CLEANING THE WASTE HOPPER
23. Hopper shown with wiper blade completely removed.
Dump the waste toner from the hopper and clean thoroughly using compressed air.
Clean the wiper blade using a lint free cloth and apply padding powder before installing.
Install the wiper blade following the previous removal steps in reverse.
ASSEMBLING THE DRUM UNIT
24.Install the corona wire assembly via the gear train side first. Insert the corona wire assembly through the opening, then slide through the opposite side.
w w w. unineti m a g i n g . c o m / t e c h n i c a l . a s p
11124 Washington Blvd., Culver City, California USA 90232 • Ph +1 310 280 9620 • Fx +1 310 280 0533 • techsupport2@uninetimaging.com
© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.
