Manuals / Mitel / Computer Equipment / Network Router

Mitel WAP54GP manual Appendix H Regulatory Information

Models: WAP54GP

1 68

Download 68 pages 56.52 Kb

Page 62

Wireless-G Access Point with Power Over Ethernet

Appendix H: Regulatory Information

FCC Statement

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna

•Increase the separation between the equipment or devices

•Connect the equipment to an outlet other than the receiver's

•Consult a dealer or an experienced radio/TV technician for assistance

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

Safety Notices

Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord. Do not use this product near water, for example, in a wet basement or near a swimming pool.

Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

Industry Canada (Canada)

This device complies with Canadian ICES-003 and RSS210 rules. Cet appareil est conforme aux normes NMB-003 et RSS210 d'Industrie Canada.

IC Statement

Operation is subject to the following two conditions:

1.This device may not cause interference and

2.This device must accept any interference, including interference that may cause undesired operation of the device.

Appendix H: Regulatory Information

56

Image 62

Mitel WAP54GP manual Appendix H Regulatory Information

Contents

Power Over Ethernet Wireless- GAccess Point with WIRELESSCopyright and Trademarks How to Use this User GuideWireless-G Access Point with Power Over Ethernet Chapter 5 Setting Up the Wireless-G Access Point Table of ContentsChapter 2 Planning Your Wireless Network Chapter 6 Configuring the Wireless-G Access PointAppendix A Troubleshooting List of Figures Figure 6-23 Administration - Reboot Figure 6-21 Administration - Factory DefaultFigure 6-22 Administration - Firmware Upgrade Figure 6-24 Administration - Config Managementnetwork a series of computers or devices connected together Chapter 1 IntroductionWelcome adapter a device that adds network functionality to your PCWhat’s in this User Guide? Appendix H Regulatory Information This appendix supplies the Access Point’s regulatory informationWireless-G Access Point with Power Over Ethernet Appendix I Contact InformationNetwork Topology Chapter 2 Planning Your Wireless Networkssid your wireless networks name RoamingNetwork Layout Wireless-G PowerGreen. The Power LED lights up when the Access Point is powered on receiving data from a wireless deviceThe Back Panel Connections for Setup OverviewWall-Mount Option Placement OptionsStand Option Setup Navigating the Utility SetupWireless Status AdministrationAP Mode snmp the standard network management protocol on the InternetThe Setup Tab IP SettingsThe Setup - Time Tab TimeThe Wireless - Basic Wireless Settings Tab Wireless NetworkTx Rate Limiting. You can limit the maximum data rate used in your network to save bandwidth and power consumption on client devices. The actual data rate is determined by an Auto-Fallback mechanism between your Access Point and a client device. The default is 54 Mbps Mixed or G-Only mode, 11 Mbps for B-Only mode The Wireless - Wireless Security Tab Wireless SecurityWPA2-Personal WPA2-Personal MixedWPA-Enterprise WPA2-EnterpriseWPA2-Enterprise Mixed RADIUS Select MAC Address From Networked Computers The Wireless - Wireless Connection Control TabWireless Connection Control The Wireless - Advanced Wireless Settings Tab Advanced WirelessMore for additional details The AP Mode Tab MAC AddressWireless Repeater Wireless Bridge Web Access The Administration - Management TabAP Password SNMPPage The Administration - Log Tab More for additional details Factory Default The Administration - Factory Default TabThe Administration - Firmware Upgrade Tab Firmware UpgradeThe Administration - Reboot Tab RebootThe Administration - Config Management Tab Config ManagementLocal Network The Status - Local Network TabInformation The Status - Wireless Tab The Status - System Performance Tab System PerformanceWireless-G Access Point with Power Over Ethernet The Status - System Performance TabWhat is the IEEE 802.11b standard? Appendix A TroubleshootingCan the Access Point act as my DHCP Server? What is the IEEE 802.11g standard?What is Infrastructure? What IEEE 802.11g features are supported?What is Ad-hoc? What is roaming?What is DSSS? What is FHSS? And what are their differences? What is the ISM band?What is Spread Spectrum? Can Linksys wireless products support file and printer sharing?How do I resolve issues with signal loss? What is a MAC Address?How do I reset the Access Point? Does the Access Point function as a firewall?Security Threats Facing Wireless Networks Appendix B Wireless SecuritySecurity Precautions SSID. There are several things to keep in mind about the SSID WPA Pre-Shared Key. If you do not have a RADIUS server, select the type of algorithm, TKIP or AES, enter a password in the Pre-Shared key field of 8-64 characters, and enter a Group Key Renewal period time between 0 and 99,999 seconds, which instructs the Router or other device how often it should change the encryption keys Appendix C Upgrading Firmware Appendix C Upgrading FirmwareShared Resources Appendix D Windows HelpTCP/IP Network Neighborhood/My Network PlacesAppendix E Glossary Domain - A specific name for a network of computers Packet - A unit of data sent over a network Router - A networking device that connects multiple networks together Topology - The physical layout of a network 802.11g 14dBm @ Normal Temp 802.11b 18dBm Normal Temp Appendix F SpecificationsIEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u, IEEE802.3af Operating Humidity Wireless-G Access Point with Power Over EthernetAppendix F Specifications Storage HumidityAppendix G Warranty Information Appendix H Regulatory Information Règlement d’Industry Canada Wireless-G Access Point with Power Over Ethernet Appendix H Regulatory InformationWireless-G Access Point with Power Over Ethernet Appendix H Regulatory InformationWireless-G Access Point with Power Over Ethernet Appendix H Regulatory InformationDual-Band Wireless Access Point Appendix H Regulatory InformationAppendix I Contact Information