Preparation/SetUp (continued)
Telnet setting
Setting of password, display language, LAN control, and PJLink™ certification using telnet.
This section describes how to set the password, display language on the ProjectorView screen, LAN control, and PJLink™ certification that are necessary for the operation state control tool (commercially available) that uses the projector operation control/monitor tool ProjectorView and the industry standard PJLink™ protocol.
1 | Start the | ||
• | Select [Start] - [All Programs] - [Mitsubishi] - | ||
| |||
|
| [Mitsubishi Projector - Control Device Installer] (in | |
|
| the case of Windows® XP). | |
|
| ||
2 | Press the + buttons on the left pane to expand the | ||
tree structure until the IP address you set appears. | |||
| |||
3 | Click the Telnet Configuration tab. |
|
4 | Select the Connect tab. Press the Enter key within | |
5 seconds after the message shown on the right | ||
| ||
| appears. | |
| • When it passes 5 seconds without any operation | |
| on this screen, the screen is shaded and no key | |
| operation is accepted. In this case, click the | |
| Connect button again to continue setting. |
5
The setting menu appears.
