Mitsubishi Electronics EN-1 ProjectorView Virtual Remote controller, Mail notification function

ProjectorView (continued)

VIRTUAL REMOTE controller

Put a checkmark in the box of the Virtual remote enabled on the ProjectorView main screen, and click the VIRTUAL REMOTE button. The following Virtual Remote window appears.

For the functional descriptions of each button, see the user manual of the projector.

E-mail notification function

In case of an error or abnormality in the projector, e-mail notification is automatically sent to the designated address to notify of the error or abnormality.

To use this function, perform the following steps.

1Enable the LAN control function. (See page 10.)

2Set the SMTP IP address, E-mail address, E-mail host, and E-mail from.

Once the above-mentioned items are set, the e-mail notification function remains enabled even when the browser (ProjectorView screen) is closed.

Example of notification: Alert on lamp life end

ProjectorView Alert:

The lamp has reached its maximum usage. Replace the lamp and reset lamp counter. See user guide for complete instructions.

Projector name : abc

Projector model : WD2000

Projector location : 10Factory-5F

Serial number : 12345

Operating hours : 2146 hours and 43 minutes

Lamp hours : 5000 hours and 0 minute

Installation date: 2006/06/02

Last lamp replacement date: 2006/07/15

Last maintenance date: 2006/08/03

(Note 3)

•In case of a command error, e-mail notification isn’t sent.

•When the LAN control is enabled, serial RS-232C commands may not be transmitted.

•You can’t control the LAN/serial RS-232C commands for about 10 seconds after turning on the main power of the projector.

•When commands for LAN control and for RS-232C control are issued at the same time, the LAN control command overrides the RS-232C control command.

•While a test pattern is displayed or a password is entered, you can’t change the lamp mode and enable and disable the MUTE function.

•Response may be delayed depending on the operating state of the projector.

•The DHCP mode may not operate with certain devices (routers etc.).

•When you turn on the projector by pressing the ON/OFF button on the ProjectorView main screen, other commands are not accepted for about 1 minute.

•E-mail notification is issued twice: at the time of occurrence of an alert/error and 2 hours after the occurrence.

To use the e-mail notification function, configure the initial settings in advance as described on the next page.

EN-14