Mitsubishi Electronics EX200U Magnifying and searching for details, Correcting keystone

Correcting keystone

Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs when the projector is not perpendicular to the screen.

To correct this, besides adjusting the height of the projector, you will need to manually correct it following one of these steps.

•Using the remote control

Press / on the projector or remote control to display the Keystone correction page. Press to correct keystoning at the top of the image. Press to correct keystoning at the bottom of the image.

• Using the OSD menu

1. Press MENU/EXIT and then press / until the DISPLAY menu is highlighted.

2. Press to highlight Keystone and press MODE/ENTER. The Keystone correction page is displayed.

3.Press to correct keystoning at the top of the image or press to

correct keystoning at the bottom of the image.

Press / . Press /

Magnifying and searching for details

If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for navigating the picture.

•Using the remote control

1.Press MAGNIFY +/- to display the Zoom bar.

2.Press MAGNIFY + to magnify the center of the picture. Press the key

repeatedly until the picture size is suitable for your need.

3. Use the directional arrows (, , , ) on the projector or remote control to navigate the picture.

4. To restore the picture to its original size, press AUTO. You can also press MAGNIFY -. When the key is pressed again, the picture is further reduced until it is restored to the original size.

•Using the OSD menu

1.Press MENU/EXIT and then press / until the DISPLAY menu is highlighted.

2.Press to highlight Magnify and press MODE/ENTER. The Zoom bar is displayed.

3.Repeat steps 2-4in the section of "Using the remote control" above. Or if you are using the projector control panel, continue to the following steps.

4.Press on the projector repeatedly to magnify the picture to a desired size.

5.To navigate the picture, press MODE/ENTER to switch to the panning mode and press the directional arrows (, , , ) to navigate the picture.

6.Use the directional arrows (, , , ) on the projector or remote control to navigate the picture.

7.To reduce size of the picture, press MODE/ENTER to switch back to the zoom in/out functionality, and press

AUTO to restore the picture to its original size. You can also press repeatedly until it is restored to the original size.

The picture can only be navigated after the picture is magnified. You can further magnify the picture while searching for details.

EN-24