Mitsubishi Electronics EX200U Personalizing the projector menu display, Direct power off

1.Repeat steps 1-2above.

2.Press to highlight Volume and press / to select a desired sound level.

Personalizing the projector menu display

The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do not affect the projection settings, operation, or performance.

•Menu display time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the length of time the OSD will remain active after your last key press. The time length ranges from 5 to 30 seconds in 5-second increments. Use / to select a suitable time frame.

•Menu position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD position in five locations. Use / to select a preferred position.

•Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD menus. Use / to select your language.

•Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be displayed during projector start-up. Use / to select a screen.

Shutting down the projector

1. Press II POWER and a confirmation message displays prompting you. If you don't respond in a few seconds, the message will disappear.

2. Press II POWER a second time. The POWER indicator light flashes orange, the projection lamp shuts down, and the fans will continue to run for approximately 90 seconds to cool down the projector.

3. Once the cooling process finishes, the POWER indicator light is a steady orange and fans stop.

4.Disconnect the power cord from the wall socket if the projector will not

be used in an extended period of time.

• To protect the lamp, the projector will not respond to any commands during the cooling process.

•To shorten the cooling time, you can also activate the Quick Cooling function.

See "Quick Cooling" on page 36 for details.

•Do not unplug the power cord before the projector shutdown sequence is complete or during the 90-second cooling down process.

•If the projector is not properly shut down, to protect the lamp, when you attempt to re-start the projector, the fans will run for a few minutes to cool down. Press II POWER again to start the projector after the fans stop and the POWER indicator light turns orange.

Direct power off

1.The AC power cord can be pulled out during the projector is on. To protect the lamp, wait about 10 minutes before re-starting the projector. (When you attempt to re-start the projector, the fans may run for a few minutes

to cool down. In such cases, press II POWER again to start the projector after the fans stop and the POWER indicator light turns orange.

2.To protect the lamp, do not shut down the projector while the POWER indicator light is blinking green after the lamp lights up.

3.Before shutting down the projector, be sure to close the menu screen. If you shut down the projector without closing the menu, the setting data of the menu may not be saved.

ENGLISH

EN-31