8.Tighten the screw that secures the lamp.
•Loose screw may cause a bad connection, which could result in malfunction.
•Do not over tighten the screw.
ENGLISH
9.Ensure the handle is fully laid flat and locked in place.
10.Place the lamp protection film supplied with the new lamp on the lamp compartment.
11.As shown in the figure, replace the lamp cover on the projector.
12. Tighten the screws that secure the lamp cover.
• Loose screw may cause a bad connection, which could result in malfunction.
•Do not over tighten the screws.
13. Restart the projector.
Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
14.After the startup logo, open the 
to highlight Reset lamp timer and press MODE/ENTER. A warning message is displayed asking if you want to reset the lamp timer. Highlight Reset and press MODE/ENTER. The lamp time will be reset to '0'.
1
2 
2
1 
• Do not reset if the lamp is not new or replaced as this could cause damage.
•This projector uses a lamp that contains mercury. Disposal of the lamp or the projector with the lamp may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org. (For US only).
