Mitsubishi Electronics HC3 user manual Image

ON

INSTALLATION

AUTO POWER

ON

OFF

LAMP MODE

IMAGE REVERSE

BLUE

SPORT MODE

BACK COLOR

ON

SPLASH SCREEN

SETUP

IMAGE CAPTURE

OFF

AUTO POWER OFF

OFF

XGA60

opt.

1IMAGE

CONTRAST ......... Use to adjust the image contrast. The contrast becomes higher
			opt.	XGA60
as the value increases.
BRIGHTNESS ..... Use to adjust the image brightness. The image becomes
	IMAGE
brighter as the value increases.		CONTRAST		0
sRGB .................... Choose ON for projection emphasizing on the color
		BRIGHTNESS		0
reproducibility.
• When sRGB is ON, COLOR MATRIX, COLOR TEMP.,		sRGB		OFF
COLOR, TINT, and GAMMA MODE can't be adjusted.		COLOR MATRIX		COMPUTER
COLOR MATRIX . Use to adjust the color balance in each color of the image. See		COLOR TEMP.		STANDARD
page 19.		COLOR		0
COLOR TEMP. .... Use to adjust the color temperature. See page 19.		TINT		0
COLOR ................ Use to adjust the color intensity of the image.
		SHARPNESS		0
TINT .................... Use to adjust the color balance of the image. The color balance
shifts to green as the value increases and shifts to purple as		GAMMA MODE		AUTO
the value decreases. (Available only when VIDEO is chosen as
the source.)

• When the TV50 (PAL, SECAM) signal is input, TINT can't be adjusted.

SHARPNESS ....... Use to adjust the image sharpness. The image becomes sharp as the value increases. (Available only

when VIDEO is chosen as the source.)

GAMMA MODE ... When AUTO is selected, the appropriate gamma mode is automatically selected depending on the input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select SPORT for sport scenes and video sources. Select THEATER for film sources.

2 INSTALLATION AUTO POWER ON ...... When ON is chosen, the lamp is automatically lit when the

power cord is plugged in the wall outlet. Choose ON when using the projector mounted on the ceiling.

• The projector is in the stand-by mode when the lamp is off. Use the remote control to turn on the lamp.

AUTO POWER OFF .... Use to set the time elapsed before the projector enters the

stand-by mode when there is no signal input from the source. IMAGE CAPTUREUse to capture the screen for the splash screen. See page 21. SPLASH SCREEN Choose ON to display the splash screen when the power is turned on.

• The splash screen can be changed. See page 21.

BACK COLOR ...... Use to select the background from among BLUE, BLACK and IMAGE, which will be displayed

when there is no signal input from the source. When IMAGE is selected, the splash screen will be displayed.

LAMP MODE ....... Use to change the brightness of the lamp. When THEATER MODE is chosen, the lamp brightness

is kept low and the volume of the operation sound is reduced, resulting in a longer lamp replacement interval.

•The SPORT MODE lamp mode is activated by default whenever the projector is turned on. When the THEATER MODE lamp mode has been chosen, the default SPORT MODE lamp mode is switched to the THEATER MODE lamp mode in 1.5 minutes.

•When the lamp mode is switched, the projected image may flicker. This is not a product

malfunction.

IMAGE REVERSE .. Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-mounted projector. Select MIRROR INVERT for rear projection with the ceiling-mounted projector.

•When you continue projection for a long time with BACK COLOR set to IMAGE, an after-image may persist on the screen.

•Do not change the setting of LAMP MODE frequently.

ENGLISH

EN – 17