Mitsumi electronic HC3800 user manual Replacing the lamp continued, EN-38

Replacing the lamp (continued)

4.Insert the two cutout portions (h) in the slit of the projector, paste the two taping portions (g) with the tape included in the Lamp Replacement Attachment, and then fix the Lamp Replacement Attachment to the projector.

(g)

(g)

(h)

5.Pull out the lamp unit (f) in the bag by the handle

(e).

(f)

(e)

6.Remove the tape fixing the Lame Replacement Attachment, and remove the Lamp Replacement Attachment with the lamp unit remaining in the bag.

Caution:

•Pull the lamp unit out of the projector slowly. If it is pulled out quickly, the lamp may break, scattering glass fragments.

•Do not spill liquid on the removed lamp unit or do not place it near any flammable object or where children can reach to prevent injuries or fire.

7.Insert the new lamp unit, and secure it with two screws firmly.

8.Secure the lamp cover with screw (b) back again, and mount the cover (a).

Caution:

•Make sure that the lamp cover is secured firmly. Otherwise, the POWER indicator flashes red and green, disallowing the projector to be powered on.

Reset of the lamp operation time

Plug in the power cord, and reset the lamp operation time by keep pressing the t, u, and POWER buttons on the control panel at the same time.

Important:

•Unless these 3 buttons are held down at the same time, the lamp operation time isn’t reset.

•Make sure that the STATUS indicator blinks twice and the lamp operation time is reset successfully.

•The projector doesn’t turn on if the lamp cover isn’t attached securely.

•Be sure to reset the lamp operation time whenever you replace the lamp.

•Do not reset the lamp operation time unless you replace the lamp.

•The lamp is fragile. If it is broken, be careful not to cut yourself with glass fragments.

Caution:

•This projector uses a lamp that contains mercury. Disposal of the lamp or the projector with the lamp may

be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org. (For the U.S. only.)

EN-38