English-12
You can attach mounting accessories to the LCD monitor in
one of the following two ways:

1. In the upright position

2. Lay the screen face down

Lay the protective sheet on a table, which was wrapped around
the monitor when it was packaged, beneath the screen surface
so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop Stand
or other mounting accessory. Failure to follow correct mounting
procedures could result in damage to the equipment or injury to
the user or installer. Product warranty does not cover damage
caused by improper installation.
Failure to follow these recommendations could result in voiding
your warranty.
When using with other mounting accessory, it must be a VESA-
compatible mounting method and the screws must be M6 of size
and 10mm or longer of length under consideration of the thick-
ness of the mounting method. (Recommended torque: 470 -
635N•cm). MITSUBISHI ELECTRIC recommends using mount-
ing interface that comply with TÜV-GS and/or UL1678 standard
in North America.

3. Ventilation Requirements for enclosure

mounting

To allow heat to disperse, leave space between surround-
ing objects as shown in the diagram below.

4. To avoid falling down

Fasten the LCD monitor to wall using a cord or chain,
which is sufficient to support the weight of the LCD monitor
(LDT321V: approx. 17.5kg / LDT371V: approx. 22kg).
Before moving the LCD monitor, the cord or chain should
be removed.
How to Mount and Attach Options to the LCD Monitor
Tabl e
Protective Sheet
Tabletop Stand
Screw Holes
See diagram below.
Clamper
Cord or Chain
Screw
LDT321V: 360mm
LDT371V: 462mm