How to Mount and Attach Options to the LCD Monitor
You can attach mounting accessories to the LCD monitor in
one of the following two ways:
1. In the upright position
2. Lay the screen face down
Protective Sheet
Table |
Tabletop Stand
Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure to follow correct mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation.
Failure to follow these recommendations could result in voiding your warranty.
When using with other mounting accessory, it must be a VESA- compatible mounting method and the screws must be M6 of size and 10mm or longer of length under consideration of the thick- ness of the mounting method. (Recommended torque: 470 - 635N•cm). MITSUBISHI ELECTRIC recommends using mount- ing interface that comply with
3.Ventilation Requirements for enclosure mounting
To allow heat to disperse, leave space between surround- ing objects as shown in the diagram below.
4. To avoid falling down
Fasten the LCD monitor to wall using a cord or chain, which is sufficient to support the weight of the LCD monitor (LDT321V: approx. 17.5kg / LDT371V: approx. 22kg).
See diagram below.
Screw Holes
Cord or Chain
ClamperScrew
LDT321V: 360mm
LDT371V: 462mm
Before moving the LCD monitor, the cord or chain should be removed.
