Mitsubishi Electronics LT-2240, LT-3040 manual Remote Control Functions Care and Operation

Remote Control Functions: Care and Operation

Operation

Installing the Batteries:

(Figure 2)

1.Remove the remote control’s back cover by gently pressing the ridged tab in the direction of the arrow and sliding off the cover.

2.Load the batteries, making sure the polarities (+) and (-) are correct. For ease of installation, install the negative (-) side first.

For Best Results from the Remote Control:

Be within 20 feet of the equipment.

Do not press two or more buttons at the same time unless instructed to.

Do not allow to get wet or become heated.

Avoid dropping on hard surfaces.

Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.

Do not mix new and old batteries.

Do not heat, take apart, or throw batteries into fire.

Use only AAA batteries.

Operating the Remote Control:

You can use the remote to control the TV and other CABLE/DBS/DTV, VCR, DVD, and AUDIO products. Select the product you want to control by moving the slide switch to the appropriate position. The remote control has been preset to operate the TV and other Mitsubishi products. To program the remote control to operate other products, see Use of the Remote Control with Other A/V Products, page 27.

LT2240_LT3040_OG_v6.ind25

Figure 1. Remote Control Functions.

Figure 2. Installing the batteries.

The remote control may return to its initial setting when the batteries are changed. You may need to reprogram.

25

04.1.21, 4:03 PM