Mitsubishi Electronics LT-2240, LT-3040 manual Monitor Tilt/Input Terminal Access/Cable Management

Monitor Tilt/Input Terminal Access/Cable Management

Monitor Tilt

(Figure 1)

You have the ability to adjust the viewing angle and tilt of this monitor.

1.Grab the TV with two hands by placing one hand on each side of the TV.

2.Using little force, push or pull the monitor towards you for preferred viewing position. Use caution when pulling so that the base does not slide.

��

����

��

Figure 1. Monitor Tilt

Input Terminal Access/Cable Management

(Figures 2, 3 and 4)

1.Locate the two input terminal covers located on both sides of your TV (back panel).

2.Gently push the two push tabs the opposite direction and push towards the side of the TV to remove the terminal cover(s).

3.After you neatly route all of the cable downward through the cable management slots, place the terminal cover back into place, so the cover can close over them (Figure 3).

4.Position the four tabs directly opposite the four slots on the TV (Figure 3) and gently push towards the front of the TV.

5.Slide the two push tabs into the slots on the other side of the terminals until both tabs snap into place. Do not force.

6.Replace the cable management cover (shield) by lining up the three slots on the back of the television. The shield will neatly conceal your connection cables.

����

����

����

Figure 2. Input Terminal Access

����

����

����

������ �� ��������� ����� �����

Figure 4. Cable Management Cover

61

LT2240_LT3040_OG_v6.ind61

04.1.21, 4:06 PM