Adjusting the angle of projection
Screen on a flat wall with a 90 degree angle to the floor by adjusting two Adjustment feet on the bottom of the projector. If the angle cannot be corrected by them, adjust the height and angle of screen.
screen | Adjustment foot | |
(up and down) | ||
|
1.Lift the projector to the right angle.
2.Press the release button for angle adjustment to take the Adjustment foot (up and down) out of the pro- jector.
3.Release the button and keep your hands away from the projector.
4.Turn the foot to right or left to adjust for proper angle.
After using the projection,
5.Press the release button to take the projector down slowly with holding it.
When the left and right angles are different Adjust the angles with adjustment feet (right and left), which are on the bottom of the projector. When ship- ping the projector at first, the Adjustment feet are cov- ered with sponge to be parallel on a flat surface. Re- move the sponge to adjust the Adjustment feet lower. Do not lose the sponge.
•Screen on a flat wall with a 90˚ angle to the floor.
•Align projector to produce a full screen display as illustrated on page 10.
•Distance from projector to screen must be compatible with screen size chart on page 10. Note distance from screen chart.
Getting ready for projection
1.Connect the power cord provided to the projector.
2.Connect the power cord to the wall outlet.
Plug in the provided power cord directly.
| ground |
|
| terminal | ENGLISH |
3. Take off the lens cap. |
| |
|
|
Warning:
•Do not look directly into the lens when projector is “ON”.
•The lens cap is for protecting the lens. If you leave the power on with the cap on, the cap may be warped. Please remove the lens cap when you turn the power on.
•A
•The supplied power cord is used for 120V only. Never connect to any outlet or power supply having a dif- ferent voltage or frequency. If you connect to the power supply having a different voltage, please use the appropriate power cord.
•Do not place an object on the power cord and keep the projector away from heat source to avoid break- ing the power cord. A broken power cord can cause fire or electric shock.
•Do not revise or alter the power cord otherwise it may cause fire or electric shock.
Contact your dealer if the cord is broken.
Caution:
•Plug in firmly and unplug by holding the plug, not by pulling the cable out.
•Do not plug in or out with wet hands. It may cause an electric shock.
11
