Mitsubishi Electronics LVP-S120A user manual Signal

5 SIGNAL
AUTO	Use to select AUTO, USER 1 or USER 2.
HORIZ. POSITION ....	Use to adjust the horizontal position of the image.
VERT. POSITION	Use to adjust the vertical position of the image.
FINE SYNC	Use to synchronize the projector with PC input signals so
	that the image is not blurred.
TRACKING	Use to avoid image noise such as wide stripes.
RGB INPUT	The unit adjusts itself automatically when connected to
	either DVD players with a component video output
	terminal (Y, CB, CR or Y, PB, PR) or equipment with HDTV
	signal output capabilities. In cases where the unit is
	connected to equipment that include an RGB output
	terminal and which output HDTV signals, adjust the unit
	to RGB mode.
HOLD	Adjusts the image which upper side is awry.
6 SIGNAL - USER (Normally, there is no need for adjustments.)
CLAMP POSITION/
CLAMP WIDTH	If you use a PC video card or something similar, the
	brighter colors of the projected image may become blurred.
	In this case, adjust CLAMP POSITION or CLAMP
	WIDTH.
HORIZ. PIXELS ....	Use to adjust the width of the image. The image size grows
	wider as the number increases. (Adjust to the horizontal
	pixels of inputting signal for normal setting.)
VERT. LINES	Use to adjust the height of the image. The image size
	grows higher as the number increases. (Adjust to the
	vertical lines of inputting signal for normal setting.)
PLL	Use to adjust the image which upper side is awry. Select AUTO for normal setting.
VERT. SYNC	Use to adjust the image when its motion does not run naturally. Select AUTO for normal
	setting.
SQUEEZE	Set to ON when displaying DVD discs which are recorded as the squeezed image (in right
	and left direction).

ENGLISH

19