Mitsubishi Electronics M557 user manual Quick Start, English-6

Quick Start

To attach the monitor to your system, follow these instruction:

1.Turn off the power to your computer and the monitor.

2.If necessary, install the display card. For more information, refer to the display card manual.

3.For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1) Tighten all screws.

For the Mac: Connect the Macintosh Cable Adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the

15-pin mini D-SUB end of the captive signal cable to the Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.

4.Connect one end of the power cord to the monitor and the other end to the power outlet (Figure C.1).

5.Turn on the monitor (Figure D.1) and the computer.

6.This completes the installation.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User‘s Manual.

Captive Signal Cable

15-pin-mini-D-SUB

Figure A.1

English-6

01_english 6 24/5/01, 3:23 pm