Mitsubishi Electronics M557 FCC Information, Declaration of Conformity-United States only, Adress

FCC Information

1.Use the attached specified cables with the Diamond Scan 52/72 colour monitor so as not to interfere with radio and television reception.

(1)Please use the supplied power cable or equivalent to ensure FCC compliance.

(2)Shielded captive type signal cable.

Use of other cables may cause interference with radio and television reception.

2.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult your dealer or an experienced radio/TV technician for help.

If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions. The user may find the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify and Resolve Radio-TV Interference Problems”. This booklet is available from the U.S. Government Printing Office, Washington, D. C., 20402, Stock No. 004-000-00345-4.

Declaration of Conformity-United States only

Product Name:	Colour Display Monitor
Type:	Diamond Scan 52/72
Brand Name:	MITSUBISHI

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

U.S Responsible party :	NEC-Mitsubishi Electronics Display of America,Inc.
Adress :	1250 N. Arlington Heights Road ltasca, illinois 60143
Tel. No. :	(630)467-3000

To identify this product, refer to the model number found on the product.

English-2

01_english 2 24/5/01, 3:23 pm