SELECTING OPERATION MODES

AMPM

AMPM

I FEEL COOL

FAN DRY

1Press to start the operation.

2 Press to select operation mode. Each press changes mode in the following order:

(I FEEL)

(COOL)

(DRY)

(FAN)

3Press or to set the temperature.

Each press raises or lowers the temperature by 1°C.

Press to stop the operation.

• The same setting is selected the next time by simply pressing .

Operation indicator lamp

The operation indicator lamp shows the operation state of the unit.

Indication

Operation state

Room temperature

The unit is operating to reach the set

About 2°C or more away

temperature

from set temperature

The room temperature is approaching

About 1 to 2°C from set

the set temperature

temperature

Lighted

Not lighted

 

I FEEL mode

The unit selects the operation mode according to the room temperature when I FEEL is selected. When the room temperature is higher than 25°C, COOL is selected (set temperature: 24°C). When the room temperature is lower than 25°C, DRY is selected. However, when operation is stopped and then started within 2 hours, the mode which has been selected previously is operated.

Note:

During COOL operation, the set temperature may not be changed when the room temperature is more than 2°C higher than the set temperature. In this case, please wait until the room temperature drops to within 2°C of the set temperature.

COOL mode

Enjoy cool air at your desired temperature.

DRY mode

Dehumidify your room. The room may be cooled slightly.

Temperature cannot be set during DRY mode.

FAN mode

Circulate the air in your room.

Emergency operation

When the remote controller cannot be used...

Emergency operation can be activated by pressing the emergency operation switch (E.O.SW) on the indoor unit.

Each time the E.O.SW is pressed, the operation changes in the following order:

Operation indicator lamp

 

Emergency COOL

 

 

Set temperature : 24°C

 

Fan speed : Medium

Stop

Horizontal vane : Auto

Note:

The fi rst 30 minutes of operation is test run. Temperature control does not work, and fan speed is set to High.

Auto restart function

If a power failure occurs or the main power is turned off during operation, “Auto restart function” automatically starts operation in the same mode as the one set with the remote controller just before the shutoff of the main power. When timer is set, timer setting is cancelled and the unit starts operation when power is resumed.

If you do not want to use this function, please consult the service representative because the setting of the unit needs to be changed.

En-4

Page 5
Image 5
Mitsubishi Electronics MCF-SD13VD, MCF-D18VD, MCF-D24VD Operation indicator lamp, Feel mode, Cool mode, DRY mode, FAN mode