![](/images/new-backgrounds/1269085/26908511x1.webp)
Attaching LCD Options
You can attach mounting accessories to the LCD monitor in one of the following two ways:
1. In the upright position
Ventilation Requirements for enclosure mounting
To allow heat to disperse, leave space between surrounding objects as shown in the diagram to the right.
MLM300 | 100 |
| * |
|
| ||
|
|
| |
100 |
| 100 | 100 |
|
| ||
| 100 |
|
|
2. Lay the screen face down
*Ambient temperature should be less than 40 deg C
Protective Sheet
Table
Tabletop Stand
To avoid damaging the screen face, place the protective sheet on the table to lay the LCD on. The protective sheet was wrapped around the LCD in the original packaging.
This device cannot be used or installed without the Tabletop Stand or other mounting accessory. For proper installation it is strongly recom- mended to use a trained, Mitsubishi authorized service person. Fail- ure to follow Mitsubishi standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding your warranty.
When using mounting accessories, other than Mitsubishi compliant and approved, they must be
(Recommended Fastern Force: 150 ~ 170N•cm)
Mitsubishi recommends using mounting interface that comply with UL1678 standard in North America.
To avoid falling down
Fasten the LCD monitor to a wall using a cord or chain which is suffi- cient to support the weight of the LCD monitor (approx. 31.5kg).
Screw Holes
Cord or Chain
ClamperScrew
Before moving the LCD monitor, the cord or chain should be removed.
4