12 USE OF CLEANING PAPER

When the thermal head is dirty with dust and perspiration, etc., white spots or stripes may appear on the print. In this case, clean the thermal head in the following procedure BY USING THE SUPPLIED CLEANING PAPER.

1

Turn on the power.4 Close the door.

 

Press the "POWER"

Close the door

 

switch to turn on the

 

without taking out

 

power.

 

the cleaning paper.

 

 

2

Open the door.

 

 

Switch the left side

OPEN

lever to the "OPEN"

 

position.

3Insert the cleaning paper.
5Press the "FEED" button.

FEED Keep pressing the "FEED" button until you hear a beep.

Roll the cleaning paper and install into the set.

Cleaning paper

6Take out the cleaning paper.

Open the door.

OPEN Take out the

cleaning paper.

Red mark

Adjust the red mark

 

 

on the cleaning

 

paper parallel to the

 

platen roller.

Platen roller Cleaning paper

Do not pull out the cleaning paper while the door is closed.

7Repeat the steps 3-6by 2 or 3 times, and print 1-2 sheets to verify the cleaning effect.

CAUTION

0It is recommended that after printing 10 rolls of paper the unit be cleaned using the supplied cleaning paper.

0If the symptom of the dirty head is not corrected even after cleaning, your set needs repairing, contact your dealer.

0Do not pull out the sheet and the cleaning paper while the door is closed. This may cause extensive damage on the unit.

0Never use other cleaning papers. It may cause damage to the thermal head.

0This cleaning paper should be used only for cleaning the thermal head. Do not use it for other purpose.

19