Mitsubishi Electronics SE1U Connection, Placement Styles, Before connection, Preparations

Placement

Placement Styles

As shown in the figures below, this device can be placed in 4 different styles.

The factory setting is “floor-mounted front projection.” Set the placement style in the default setting menu p.30 , in accordance with your needs.

Connection

Before connection

•	Read the user manual of the device to connect to the projector.
•	Some types of computer cannot be used or connected to this projector.
	Check for an RGB output terminal, supported signal p.38 , etc.
•	Turn off the power of both devices before connecting.

Floor-mounted front projection

Floor-mounted rear

projection

Ceiling-mounted front

projection

Ceiling-mounted rear

projection

• The figure below is a sample connection. This does not mean that all of these devices

can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)

CRT monitor, etc.Computer

CAUTION

•Always obey the instructions listed in IMPORTANT SAFEGUARDS when placing the unit.

•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.

•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that fact.

Projection Distance and Screen Size

Use the figures and table below to determine the screen size and projection distance. (Screen sizes are approximate values for full-size picture with no keystone adjustment)

	To audio output		Preparations
Audio cable (for PC)
(supplied)		To RGB
		output
			RGB cable (for PC)
			(supplied)

Monitor cable Mini D-sub 15P-BNC

(not supplied)

As seen from above

Screen

(Width)	90°�
Screen Size

As seen from the side

(Height)SizeScreen Lens center

H

Projection Distance a

a Values listed below may differ from actual values.

Screen Size			Projection	Height
			Distance(a)
(Inch)	Width(cm)	Height(cm)	(m)	(cm)
40	81	61	1.5	6.1
60	122	91	2.3	9.1
80	163	122	3.1	12.2
100	203	152	3.8	15.2
150	305	229	5.8	22.9
200	406	305	7.7	30.5
250	508	381	9.7	38.1
300	610	457	11.6	45.7

Audio cable (for a VCR) (supplied)

	To Y/CB/CR output				S-Video cable
	Green (Y)				(not supplied)	Control cable
	Blue (CB),				Video cable
	Red (CR)	Yellow
					(supplied)
		(to video output)
	Conversion		To audio			p.40
To audio			output
	adapter		White (L)
output					To S-Video	To RS-232C terminal
	BNC-pin		Red (R)
White (L)
Red (R)	(not supplied)				output
	DVD player			VCR		Computer (for control)

Note

•The AUDIO terminal can be used with all the devices for input (source) terminal.

a is the distance (m) between the lens and the screen, and corresponds to a range of 1.5 m to 11.6 m.

18 19