Mitsubishi Electronics WD-52725, WD-62525 Connecting a VCR to an Antenna or Wall Outlet Cable

Connecting VCR Video and Audio to an Antenna or Wall Outlet Cable

VCR Video and Audio to an Antenna or Wall Outlet Cable

Figure 5

A two-way RF splitter, 3 coaxial cables, right and left audio cables and a S-Video or Video cables are required. These are not included with the TV.

1.Connect the incoming cable or Antenna to IN on the RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANTENNA IN on the VCR back panel.

3.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the TV back panel.

4.To use the TV speakers with the VCR, connect a

set of audio cables from AUDIO OUT on the VCR back panel to INPUT-1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel. If your VCR is mono (non-stereo), connect only the white (left) cable.

5.Connect either an S-Video or Video cable from VIDEO OUT on the VCR back panel to INPUT-1 VIDEO on the TV back panel. Only one type of video cable should be connected. S-Video is recommended, if available.

6.For NetCommand® controlled recordings, connect a set of audio cables from AUDIO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel.

7.Complete the NetCommand controlled recordings connections by connecting a Video cable from VIDEO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 on the TV back panel.

1.	SPLITTER	OUT
IN
Incoming	TWO WAY	OUT
Cable

3.

2.

		6.		7.
TV back panel section
		IEEE1394
	INPUT/OUTPUT
	IR EMITTER	PC
	NetCommand	VGA/SVGA/XGA/
		720p	AUDIO	VIDEO	S-VIDEO	MONITOR
		60 Hz	L(MONO)
		R				OUTPUT
L	DVI	L
	Analog Audio					AUDIO 2
R	ANT-2	R
		PC-
	AUX	AUDIO				AUDIO/VIDEO 1
	DTV/
	CABLE/					INPUT-1
	VHF/
	UHF
HDMI	ANT-1	PC-				INPUT-2
M-LINK	MAIN	INPUT
3.
	M-LINK
	CONTROL/
	RS-232C	DIGITAL
		AUDIO

4. 5.

Attach only one cable type

6.

VCR back panel

�� ����� 2.

If your VCR has a video channel	4.
or RF ON/OFF switch, set it to OFF.
	5.

S-Video 5. 7.

recommended if available

Note:

NetCommand® will assume your VCR is connected to inputs as shown on this page. If you use any other inputs for your VCR or add a second VCR, this change must match in the NetCommand system. See Edit NetCommand... in Chapter 3 for more information.

Figure 5. Connecting a VCR to an Antenna or Wall Outlet Cable

20