Mitsubishi Electronics WD-62525, WD-52725 manual Front Control Panel, System Reset, Indicators

Front Control Panel

The buttons on the Front Control Panel highlighted in gray are duplicated on the remote control. The top row of labels show the control functions when there are no TV menus displayed on the screen. The bottom row of labels show the control functions when the TV menus are displayed on the screen or when a special function has been activated. See Remote Control Overview, for further details on the functions of these buttons.

System Reset

If the TV will not respond to either the remote control or the front panel controls and/or will not power Off, press the SYSTEM RESET button with a pointed item like the end point of a paperclip. The TV will turn Off and the TIMER light will flash quickly for about one minute. When the TIMER light stops flashing, you may again turn on the TV. The changes you made the last time the TV was on before you used the SYSTEM RESET button may be lost, however, the changes that were previously saved are not lost.

SYSTEM	LAMP STATUS TIMER
RESET

Indicators

Please refer to the table below for conditions when the indicator lights will display.

COLOR	LAMP LIGHT	TIMER/	COLOR	STATUS LIGHT INDICATOR
	INDICATOR	POWER
None (off)	Power off	Power off	None (off)	Power off
Green	n/a	Power on	Green	n/a
(steady light)			(steady light)
Green	n/a	Starting	Green	n/a
( fast blinking light)		up*	( fast blinking light)
Green	Power just turned off,	TV Timer	Green	n/a
(blinking light)	TV cooling down (1	is set	(blinking light)
	minute). Cannot turn
	the TV back on until
	blinking stops.
Yellow	Lamp life end warning.	n/a	Yellow	Operating temperature is too high.
(steady light)	A new lamp should be		(steady light)	The dust filter may be dirty. See
	purchased.			Appendix H.
	See Appendix H.			or
				The room temperature too hot. Turn off
				TV until the room is cooler.
Yellow	Lamp cover door is	n/a	Yellow	The filter cover is open or not secure.
(blinking light)	open		(blinking light)	See Appendix H.
	or no lamp installed.
	See Appendix H.
Red	Lamp has failed,	n/a	Red	Service required.
(steady light)	replacement is		(steady light)	Turn off TV and call your dealer or a
	required.			Mitsubishi Authorized Service Center.
	See Appendix H.			See www.mitsubishi.com or call 1-800-
				332-2119.
Red	n/a	n/a	Red	Service required.
(blinking light)			(blinking light)	Turn off TV and call your dealer or a
				Mitsubishi Authorized Service Center.
				See www.mitsubishi.com or call 1-800-
				332-2119.

*Each time the TV is plugged into a wall electrical outlet, when power is restored after a power failure, or when using the SYSTEM RESET button, this light will flash for about one (1) minute.

A/V Reset

There may be times when you wish to reset the A/V (Audio and Video) settings back to the factory defaults. To return all of the settings at once, press GUIDE and FORMAT on the front panel at the same time. To reset the defaults for individual devices, use the A/V Memory Reset selection on the AudioVideo menu.

11