MODELS:
LED Indicator Diagnostics
The front panel LEDs provide an indication of the set’s operation, and the possible cause of a malfunction. There are three front panel LEDs, “Power”, “Status” and “Lamp”. The LED display shows the current status or indicates a possible malfunction.
NORMAL LED INDICATIONS
Power/Timer | Status LED | Lamp LED | Condition | |
LED | ||||
|
|
| ||
Off | Off | Off | Off (Standby) | |
Fast Blink | Off | Off | Initialization (40 - 60 seconds) (AC Off) | |
Green | ||||
|
|
| ||
|
|
|
| |
Off | Off | Green Blink | Lamp cooling (90 seconds after PTV Off) | |
(Fan is still working) | ||||
|
|
| ||
|
|
|
| |
Green | Off | Off | Power On | |
Slow Blinking |
|
|
| |
Green | Off | Off | Power On Timer is set |
ABNORMAL LED INDICATIONS
Pow er/Timer | Status LED | Lamp LED | Condition | |
LED | ||||
|
|
| ||
Off | Yellow | Off | Temperature high - room too hot. | |
Temperature sensor is disconnected | ||||
|
|
| ||
Off | Off | Blinking | Lamp cover open. | |
Yellow | ||||
|
|
| ||
|
|
| Lamp Failure - Lamp failed to turn On. | |
Off | Off | Red* | Lamp is broken | |
|
|
| Lamp turns Off during | |
Off | Blinking Red | Off | Fan Stopped | |
|
|
| Circuit failure (short) | |
|
|
| Disconnected DVI cable, chassis to engine | |
Off | Red | Off | No | |
|
|
| the lamp On. | |
|
|
| Ballast UART communication problem. |
* A red Lamp LED only occurs after 2 attempts to light the lamp.
Each attempt (pressing POW ER) must be at least 65 seconds apart. During each attempt ballast striking may be audible.
3. Error Code Operational Check
Note: The TV must be in “Shut Down” and not have been switched Off, to perform the Error Code Opera-
tional Check. When the TV is switched Off, the code automatically resets to “12” No Error.
Pressing the front panel “INPUT” and “MENU” buttons at the same time, and holding for 5 seconds, activates the Error Code Mode. The “TIMER LED” flashes denoting a two digit Error Code, or indicating no problem has occurred since the last Initialization.
Note: The front panel buttons must be used, NOT those on the Remote Control.
•The number of flashes indicates the value of the MSD (tens digit) of the Error Code.
•The flashing then pauses for approximately 1/2 second.
•The LED then flashes indicating the value of the LSD (ones digit) of the Error Code.
•The Error Code is repeated a total of 5 times.
Example: If the Error Code is “23”, the LED will flash two times, pause, and then flash three times.
Downloaded From | Page 24 |
|