Mitsubishi Electronics WS-65515A, WS-65615A Device Learn Screen, Device Advanced Learn Screen

Edit NetCommand®, Adding Devices, continued

[Device] Learn Screen

Figure 16

Shown only if “Learn” was selected (Figure 15)

1.Press ADJUST , , or to select the check box for each function to be learned.

2.Press ENTER and the function name will begin to flash to confirm the ready-to-learn status.

3.Press the button on the device’s remote control that corresponds to the selected function. A check mark will appear and the function name will stop flashing. This confirms the signal learned status.

4.To test the learned command, press ENTER on the TV remote while the learned function is highlighted. The device should perform the selected function. The device needs to be turned on and the IR emitters properly placed for the test to be successful (see page 22 for IR emitter placement).

5.Repeat for each function to be learned.

6.To erase a learned function, highlight the check box for that function and press CANCEL.

7.When the function signals have been learned, press

ADJUST to select Next> and move to the [Device] Advanced Learn screen.

NOTE: When learning the device’s remote control signals, point the device’s remote control at the TV screen.

Hint: If the device’s remote control uses a single button for both Power On and Power Off, don’t learn the Power Off function.

[Device] Advanced Learn Screen

Figure 17

After learning the basic device keys, the [Device] Advanced Learn screen allows you to learn any special keys for your device. Most common IR remote control signal formats can be learned by NetCommand.

A table of specialized device keys is shown in Appendix E. You only need to learn the functions your devices respond to and can ignore the functions that do not apply to your device.

Figure 17 [Device] Advanced Learn screen

Name Screen

Figure 18

The Name screen allows you to change the default name for each device to a custom name of up to eight characters (including a blank space), selecting from letters, numbers and nine different characters. Press ADJUST or to select each letter, then press ENTER to move to the next position. Press CANCEL on the remote to delete the current letter and move back one character position. When in the first position, the CANCEL button will return the name to the default name.

Figure 16. [Device] Learn screen

Figure 18. Name screen

40