Mitsubishi Electronics WS-55615A, WS-65515A, WS-65615A VCR to Antenna or Wall Outlet Cable, Red

Connecting VCR Video and Audio to an Antenna or Wall Outlet Cable

VCR to Antenna or Wall Outlet Cable

Figure 5

A two-way RF splitter, 3 coaxial cables, right and left audio cables and S-Video or Video cables are required. These are not included with the TV.

1.Connect the incoming cable or Antenna to IN on the RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANTENNA IN on the VCR back panel.

3.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the TV back panel.

4.To use the TV speakers with the VCR, connect a set of audio cables from AUDIO OUT on the VCR back panel to INPUT 1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel. If your VCR is mono (non-stereo), connect only the white (left) cable.

5.Connect either an S-Video or Video cable from VIDEO OUT on the VCR back panel to INPUT 1 VIDEO on the TV back panel. Only one type of video cable should be connected. S-Video is recommended, if available.

6.For NetCommand® controlled recordings, connect a Video cable from VIDEO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 on the TV back panel.

7.Complete the NetCommand controlled recording connection by connecting a set of audio cables from AUDIO IN on the VCR back panel to MONITOR OUTPUT AUDIO/VIDEO 1 AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV back panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel.

	Attach
	only
	one
	cable	S-Video
	type
		recommended
		if available
		5.
		White
2.		4. Red

TV back panel

INPUT		MONITOR OUTPUT
1	2	AUDIO/VIDEO 1	AUDIO 2

S-VIDEO
	6.
VIDEO
AUDIO-	White
(MONO)
LEFT/
AUDIO-	Red
RIGHT

2.

VCR back panel

IN	SPLITTER	OUT
	WAY

COMPONENT

7.

HS-U748 4. Red

Incoming Cable 1.

TWO	OUT
	3.

YPbPr (480i/480p/1080i)

1 2

TUBE

R

Y

Pb

Pr

White
5.	6.	7.

		3.	DVI
			Analog Audio
			Digital Video
			Digital Audio
	ANT-2	ANT-1
	AUX	MAIN
SERVICE	IEEE1394	DIGITAL
PORT	INPUT/OUTPUT	AUDIO
		CableCARD	SLOT
	– (DTV/CABLE /VHF/UHF) –

AUDIO-

LEFT/

(MONO)

AUDIO- RIGHT

If your VCR has a video channel	5.
or RF ON/OFF switch, set it to OFF.
		W	R
	Attach	h	e
		i	d
	only	t
	one	e
	cable
S-Video	type
recommended
if available

Figure 5. Connecting a VCR to an Antenna or Wall Outlet Cable

Note:NetCommand® will assume your VCR is connected to inputs as shown here. If you use any other inputs for your VCR or add a second VCR, this change must match in the NetCommand system. See Edit NetCommand... pages 35-42for more information.

IMPORTANT

Additional connection cables are not provided with the TV. They are available at most electronic stores.

17