Mitsubishi Electronics XD110R Sharpness, Gamma Mode, Auto Power on, Auto Power OFF, Splash Screen

Menu operation (continued)
1 IMAGE
CONTRAST	Use to adjust the image contrast. The contrast becomes
		opt.
	higher as the value increases.		XGA60
BRIGHTNESS	Use to adjust the image brightness. The image becomes	IMAGE
	brighter as the value increases.
		CONTRAST	0
WHITE ENHANCE	Use to adjust the white level of the projected image.
		BRIGHTNESS	0
	Select AUTO for normal use.
		WHITE ENHANCE	AUTO
COLOR TEMP	Use to adjust the color temperature. See page 18.
		COLOR TEMP.	STANDARD
COLOR	Use to adjust the color intensity of the image.
		COLOR	0
TINT	Use to adjust the color balance of the image. The color
		TINT	0
	balance shifts to green as the value increases and shifts
	to purple as the value decreases. (Available only when	SHARPNESS	0
	VIDEO or S-VIDEO is chosen as the source.)	GAMMA MODE	AUTO

	• When the TV50 (PAL, SECAM) signal is input, TINT
	can’t be adjusted.
SHARPNESS	Use to adjust the image sharpness. The image becomes sharp as the value increases. (Not available
	with certain signals.)
GAMMA MODE	When AUTO is selected, the appropriate gamma mode is automatically selected depending on the
	input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select STAN-
	DARD for sport scenes and video sources. Select THEATER for film sources.

2 INSTALLATION

AUTO POWER ON	When ON is chosen, the lamp is automatically lit when
					opt.	XGA60
	the power cord is plugged in the wall outlet. Choose ON
	when using the projector mounted on the ceiling.
		INSTALLATION
	• The projector is in the stand-by mode when the lamp			AUTO POWER		OFF
	is off. Use the remote control to turn on the lamp.			ON
				AUTO POWER		OFF
AUTO POWER OFF	Use to set the time elapsed before the projector enters			OFF
			ON	SPLASH		ON
	the stand-by mode when there is no signal input from the			SCREEN
	source.			BACK COLOR		BLUE
SPLASH SCREEN	Choose ON to display the splash screen when the power			LAMP MODE		STANDARD
	is turned on.			IMAGE		OFF
				REVERSE
BACK COLOR	Use to select the background from among BLUE and
	BLACK, which will be displayed when there is no signal input from the source.
LAMP MODE	Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept low and
	the projector operating noise is reduced, resulting in a longer lamp replacement interval.

	• When the lamp mode is switched, the projected image may flicker. This is not a product malfunc-
	tion.
	• Do not change the setting of LAMP MODE frequently.
	• When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW
	about one minute after turn-on.
IMAGE REVERSE	Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-mounted
	projector. Select MIRROR INVERT for front projection with the ceiling-mounted projector.

EN-16