swru266
4 Getting Started
4.1Development Kit Content
The development kit includes the following main components:
RF remote control
A complete cost optimized RF4CE remote control reference design with integrated PCB antenna. The remote control can be programmed using the debug interface.
Target Module
Interface board for connecting I/O signals to typical remote applications. The following interfaces are accessible:
-UART over USB virtual serial port
-UART, CMOS signal level
-SPI
-I2C
-IR receiver/transmitter
CC2533EM
This is the CC2533 Evaluation Module (EM) with the RF IC reference design. Use the EM as reference design for antenna and RF layout. To be plugged into the Receiver module. The CC2533EM module includes both a
CC Debugger
USB Debug Interface for programming and debugging applications running on the remote control and target board.
For programming the CC Debugger is used with the SmartRF flash programmer SW
For
6/25