Texas Instruments CC2533 manual List of Figures, List of Tables

swru266

List of Figures
Figure 1: Remote Control Key layout	8
Figure 2: Target module layout	9
Figure 3: Assembled target module	10
Figure 4: Connecting the target module for the first time (Windows XP)	11
Figure 5: Select automatic installation of software (Windows XP)	11
Figure 6: The driver installation is completed (Windows XP)	12
Figure 7: Correct target module setup (Windows XP)	12
Figure 8: SmartRF flash programmer interface	14
Figure 9: Connecting the remote control to the CC Debugger	15
Figure 10: Connecting the target module to the CC Debugger	16
Figure 11: USB interface selection with 0-ohm resistor	18
Figure 12: Serial flash interface details	19
Figure 13: Changing polarity of IR control signal to active high	20
Figure 13: Opening the remote control, step one	21
Figure 14: Opening the remote control, step two	21
Figure 15: Short pin 1(GND) and pin11 (SDA)	22
Figure 16: Installing the EEPROM burner driver	22
Figure 17: Using the EEPROM burner software	23

List of Tables
Table 1: EM module interface	17
Table 2: Interface header pinout	19
Table 3: Debug Header pinout	19

3/25