Chapter 2 | Connection and Setup |
|
|
Setup
Network Clock Sync
PLEASE TAKE NOTE OF THE FOLLOWING:
The Momentum network MUST have ONE mi8 that is assigned CHANNEL 1. This assignment is used to synchronize all of the device clocks on the network. Without this assignment, the system clock will not sync and audio ‘clicks’ will be heard.
Using the Control Panel
The mo8 unit includes a control panel with an LED display and two push buttons (F1 and F2). The device can be configured through a series of key strokes using F1 and F2. The control panel will only control the local device and cannot change other units via the network.
Power Indicator
Status Indicator
Display | F2 - Mode Select / Increase Value |
| F1 - Mode Edit / Decrease Value |
|
|
|
|
|
| |
Button/LED | ||||||
|
| Description | ||||
F1 Mode Select: | F1 activates the edit mode within a particular function. | |||||
F2 Mode Select: | F2 generally selects which function to edit. | |||||
Power Indicator: | The power indicator shows that a power source is connected to the | |||||
|
|
| Momentum units. The LED is connected to the digital power source. | |||
|
|
| All other power sources in the system can be monitored via the PC | |||
|
|
| software. | |||
Status Indicator: | The status indicator is a | |||||
|
|
| tum Network connections have been found and the network is run- | |||
|
|
| ning. RED indicates there are one of two problems; | |||
|
|
|
| 1) An Ethernet link is not established or is not connected. | ||
|
|
|
| 2) The audio sync packet (channel 1) is not found. | ||
|
|
|
|
|
|
Momentum mo8 Manual | 14 |