Monster Cable MPA5150 owner manual AMPLIFIER CONNECTIONS MPA 5150 REAR PANEL

AMPLIFIER CONNECTIONS

MPA 5150 REAR PANEL

1.AC Power Receptacle – Connect to your AC power line from the wall using the supplied power cord. Monster recommends connecting all electronic components to a Monster PowerCenter for clean, noise free AC power and protection for system components.

2.Voltage Selection Switch – Selects the input supply voltage. Make sure that this switch is set to 115V. (In the US, nominal AC power is 120V.)

3.Main Power Fuse – 12A 120V Slow-Blow fuse protects the amplifier from power overload. Replace only with same type fuse rated at the same amperage.

4.Remote On/Off – Allows amplifier to be automatically turned On or Off when receiver or preamplifier is turned On or Off. One trigger cable and one power transformer are included with each amplifier.

5.Selectable Balanced/Unbalanced Input Switch – Selects between the unbalanced and balanced input for each channel. Verify that the switch is at the proper setting for the type of input used.

6.Amplifier Input – Monster has provided both Unbalanced (RCA) and Balanced (XLR) inputs to match a variety of receivers and preamplifiers. Do not use both inputs at the same time.

7.Grounding Connection – Connection to ground for other components in the system. If using a Monster PowerCenter, connect the MPA 5150 ground post to the PowerCenter’s ground post to maintain the lowest possible noise floor.

17