7
Lift mounting neck to mounting Plate and align screws.
10
Place the Main holder over the blade and install 3 screws and tighten securely. Repeat this process again for each blade
13
Install upper glass to top of fan.
16
Insert downrod into yoke on top of the Fan Body. Align the hole in the Downrod with the hole in the Yoke. Insert the Pin through the Yoke and Downrod until the point appears on the other side. Install the Keeper Pin
8
Secure mounting neck to the mounting plate with four screws to become a complete mount- ing bracket.
11
Install Blade / blade holder assembly to fan motor using large motor screws. Repeat this process 4 more times until all blades are installed to the fan.
14
Install tines of upper cage by inserting into the 4 slots on the hub. Tighten using Phillips screwdriver. Repeat 3 more times until all 4 tines are in place.
17
Tighten the 2 Set screws on the Yoke once the downrod is in place.
9
Place Floating decorative holder onto blade. The tabs should align with the holes in the blade.
12
Install 3 each Max 25 Watt cande- labra base bulbs into the sockets on top of the fan as shown.
15
Install Canopy Cover, Cage Assembly and Yoke cover onto the Downrod. Next thread the fan leadwire from top of fan through the downrod.
18
Slide the Yoke Cover, and cage down on the fan body. The Cage should engage 4 slots in the upper glass. Tighten the Set Screw in on the top of the Cage. This will prevent any rattling.
