7
Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
10
Make sure the studs protruding from the bottom of the Mounting bracket are installed with threads all the way through the bracket.
13
House Fan
Black |
|
|
|
| Blue | |
|
|
| ||||
|
|
|
| Black | ||
|
|
|
| |||
White |
|
|
|
|
| |
|
|
|
| |||
|
|
|
|
| White | |
|
|
|
|
| ||
|
|
|
|
| ||
Ground |
|
|
|
| Green | |
Connect black and blue wire from fan to Black or (Hot) wire from house. Connect White wire from Fan to White (Neutral) wire from house. Connect Ground leads from mounting bracket and downrod to Ground lead from house. Refer to Safety Tips section of manual.
16
Remove side covers from canopy expos- ing 4 holes. 2 closed holes and 2 open “L” shape holes.
8Canadian mounting only
Safety Cable
Lag Screw
For Canadian installation in both flush and down- rod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
11
Cover Ring
Lift Conopy allowing the 2 studs to protrude through the canopy.
14
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded con- ductor and the
17
Center | Canopy |
Hole | Larger |
| |
Smaller | holes |
| |
holes |
|
Place canopy on top of the fan motor allowing the yoke to pass through the large hole in the center of the canopy. Align the 3 larger holes around the center hole with the 3 screws already installed in the fan. Install 3 flush mount screws provided into smaller holes and tighten securely.
9
Remove all 4 screws from Mounting bracket. These screws will not be needed for Downrod Mode installation
12
Next lift the cover ring and install knurled nuts as shown. Tighten the knurled nuts securely. The canopy should adjust for any irregularity in the ceiling or Outlet box.
15 Flush Mount Installation
Pass leadwires and safety cable through the canopy.
18 | Hands free hook |
|
Hang fan from mounting bracket by the hands free hook into a closed hole on the edge of the Canopy. Note: For Canadian mounting refer to Step #8.
