19
Fan Switch
Light Switch
Wall
Control
For control of fan and optional light from wall location, follow diagram above. NOTE: A profes- sional electrician is recommended for this type of installation.
22
Install 3 screws and washers per blade and tighten securely. Repeat for all 5 blades
25
Loosen 3 screws with key slots and remove 1 screw without slot from motor plate and save screw.
28
capacitor
Remove the double sided tape from capacitor and stick capacitor to switch housing.
20
23
Remove the steel motor stabilizing plate and discard.
26
Install switch housing plate by twist- ing plate with key hole slots into place. Replace screw removed and tighten the 4 screws securely.
29
Remove 4 screws and save to install switch housing.
21
Raise the canopy up and align the two holes in the canopy with the two holes in the hanger bracket. Secure with two screws provided.
24
The screws, washers, and motor pads are
27
Connect plug from fan to switch house plug.
30
Install the switch housing using the 4 screws previously removed.