7
Lift mounting neck to mounting Plate and align screws.
10
Install 3 screws to hold glass to fan housing. Do not overtighten as this could crack the glass.
13
Place downrod into the arch yoke and align the slot in arch yoke and the hole in the downrod.
16
Remove screw and nut on tab to place arch arms in place. Save screw and nut for use later step 19.
8
Secure mounting neck to the mounting plate with 6 screws to become a complete mounting bracket.
11
Remove pin from downrod and save for later step 14. Push the yoke cover onto downrod. Thread lead wires and safety cable through the downrod.
14
Raise lead wire, safety cable, and downrod up and align with slot for pin in bottom of arch yoke. Push pin into hole in downrod. After putting in pin don’t twist downrod. Make sure pin is fully engaged in slot.
17
Place arms over the fan housing. Make sure the arms with electrical connection plugs are next to the plugs on the fan housing.
9
Lower upper glass disk onto fan housing and align 3 holes in glass with 3 holes in fan hous- ing.
12
Pull lead wires and safety cable out from the yoke about 3”.
15
Tighten set screws to hold downrod securely in the arch yoke.
18
Close up for showing tab and screw holes of fan body to place arch arms over for arch installation.
