19
Install arch mount by using screw and nut removed in step 16. Place screw through tab and tighten nut and screw securely.
22
Tighen the 3 screws holding the arch arms securely.
25
Install 6 x 15 watt candelabra tor- pedo shape bulbs.
28
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to differ- ent positiosns to have seperate control.
20
Align holes in arch arm and slot for tab with holes and tab on fan body. Start all screws in the arch arm brackets.
23
Push the yoke cover down into place.
26
Install decorative cap.
29
Hang assembled fan from the mounting brack- et. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
21
Tighen all 6 screws for arch arms securely.
24
Plug in electrical connections there are 2 double plugs from arch assem- bly one for the fan and one for the up and down lights.
27
Thread leadwires and safety cable through the canopy. Place canopy over the downrod.
30
Rotate slide on mounting bracket till it stops so the screw holes will align for 2 canopy screws in hardware pack. Tighten the 2 screws secure- ly. These will lock slide in place till ready to mount canopy. (step 34)