31Canadian mounting only
Safety Cable
Lag Screw
For Canadian installation in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
34
Lift Canopy to ceiling aligning the key hole slots with the screws on the bottom of the Mounting bracket. Rotate the canopy Counter Clockwise to lock in place. Tighten the screws to secure the Canopy. See inset for Keyhole shape
37
Loosen 2 screws and remove one and save it. Place plate’s key slotted holes over the 2 screws loosened and twist into place. Replace removed screws and tighten all 3.
40
32
Fan | House |
white | white |
black | black |
orange |
|
blue | Green |
|
Make wiring connections as indicated above. White from fan to white from remote marked N. Orange from fan to Orange from remote marked Light/up. Blue from fan to blue from remote marked down light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.
35
Attach blade brackets to blades using the blade bracket screws and wash- ers provided.
38
Plug 9 pin wire connections together.
41
33
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
36
Install all 5 fan blade assemblies to the motor as shown above. Tighten screws securely.
39
Attach switch housing to fan using the three screws provided.
42
Remove cover by snaping off from top or bottom. Install 12V battery into wall remote. Duracell MN21 / Eveready A23 / GP 23A all 12V.
Attach cover of remote by placing | Install wall control unit to outlet box |
over buttons and snaping into place. | using machine screws provided. |
