19
Ready for wiring
22
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
25
Loosen 2 screws and remove 1 screw from motor plate. Save removed screw for use later.
28
Plug ballast into the flourescent lamp.
20
Connect black from remote receiver to black or (hot) wire from house. Connect white wire from remote receiver to white (neutral) wire from house. Connect green ground leads from mounting bracket and downrod to ground lead from house. Refer to Safety Tips section of manual.
23
Lift canopy and install knurled nuts as shown. Tighten the knurled nuts securely. The canopy should adjust for any irregu- larity in the ceiling or Outlet box.
26
Connect plug from fan to switch house plug. (as shown)
29
Carefully snap flurescent lamp into clips.
21
Make wiring connections for remote receiver to fan as above diagram.
24
Attach blades to motor using screws and washers in hardware bag and tighten screws securely.
27
Install light plate with ballast to fan by twisting plate with key hole slots into place. Replace screw removed and tighten the 3 screws securely.
30
Attach glass by locating dimples in light kit with the groves in glass and twist clockwise till tight.