7
Place yoke cover on downrod. (as shown)
10
Align the hole in the downrod with the hole in the yoke. Insert th pin through the yoke and downrod until the point appears on the other side.
13
Pull down yoke cover.
16
Make sure the studs protruding from the bottom of the Mounting bracket are installed with threads all the way through the bracket.
8
Thread leadwires and safety cable through downrod. (as shown)
11
Install the keeper to pin.
14
Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
17
Remote Transmitter
Dip switches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communicate properly. If you have other fans you can set to control from one trans- mitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different posi- tions to have seperate control.
9
Place downrod into fan yoke.
12
Tighten the 2 set screws on the yoke once the downrod is in place.
15Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” lag lock screw washer
Fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house struc- ture beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.
18