Midland Radio 5001z owner manual CB Antenna, Antenna Installation, Tuning your Antenna, Page

Model 5001z Owner’s Manual

CB Antenna

How to Select, Position, Install and Tune the Right One for You

Basically, you may choose from two types of mobile CB antennas - full-length whip and loaded whip - and a variety of mounts (depending on where you locate your antenna). Midland markets a line of high-performance antennas. Visit our website at www.midlandra- dio.com to check out the selection.

Where You Locate your Antenna Does Make a Difference.

Some general rules for antenna location that can aid CB performance:

1. Put your mount as high on the vehicle as possible.

The higher the proportion of antenna length that is above the roof, the better.

2.If possible, mount the antenna in the center of whatever surface you choose.

3.Keep antenna cables away from noise sources such as the ignition system, gauges, etc.

4.Make sure you have a solid metal-to-metal ground.

5.Exercise care to prevent cable damage.

Essentially, you have five location choices: the roof, gutter, rear deck, front cowl or rear bumper. Where you decide to locate your antenna will determine the type of antenna needed.

Antenna Installation:

Follow the manufacturer's installation instructions carefully.

-Warning: Never operate your CB radio without attaching an antenna or with a broken antenna cable. This will result in damage to transmitter circuitry. -Safety notice: The antenna used for this radio must be installed to provide a separation distance of at least 20 cm (8 in.) from all persons and must not be co- located or operating in conjunction with any other antenna or transmitter.

Tuning your Antenna

Some antennas are factory tuned. However, performance can usually be improved by slightly lengthening or shortening its length, using a Standing Wave Radio (SWR) meter. For the exact procedures to be used refer to the antenna manufacturer's installation manu- al.

Page 6 www.midlandradio.com