Model 5001z Owner’s Manual
Operation Continued....
•LED Channel Display- Displays the selected channel.
•RX/TX LED Indicator- When the radio is in receive mode, the LED will be green. When in transmit mode, the LED will be red.
•Channel 9/Normal Switch- This switch is used for instant selection of emergency Channel 9 or Normal CB operation. In normal position, all 40 CB channels can be accessed by the Channel Selector Knob.
•BRT/DIM Switch- Controls the brightness of the LED channel indicator and the S/RF meter for optimum brightness for day or night time usage.
•NB/OFF Switch- When this switch is in the NB position, the RF Noise Blanker will be activated. The RF Noise Blanker is very effective for cutting down on ignition interference.
•S/RF
grill. Be sure to speak clearly in a normal voice.
How to Operate your Transceiver
You should become familiar with the controls and complete the preceding installation instructions before attempting operation of your CB.
1.Rotate the On/Off Volume Knob clockwise to turn the unit on.
2.Rotate the RF Gain Knob fully clockwise.
3.Adjust the Squelch Knob fully counter clockwise so noise is heard.
4.Adjust the volume for a normal listening level.
5.Rotate the Squelch Knob until the noise just disappears. In some cases you may need to rotate the RF Gain counter clockwise to reduce the noise level.
6.Select the desired channel by rotating the Channel Selector Knob.
7.To transmit press the PTT button on the side of the microphone. Hold the micro phone 2 to 3 inches from your lips and speak in a normal voice.
8.To receive, simply release the PTT button.
Page 8 | www.midlandradio.com |