7
Tighten both yoke set screws and lock nuts to further secure downrod.
10
Tighen set screw loosened in step 5.
13
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
16
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
8
Install upper glass over downrod onto fan body.
11
Carefully lift fan assembly onto mounting brack- et. Rotate fan so that the notch on the ball engages the ridge in the mounting bracket. This will allow
14
Install remote receiver by sliding into opening in the mounting bracket. Make sure that the dip switches on the transmitter and the receiver are set to the same positions.
17
Raise the canopy up and align the two holes in the canopy with the two holes in the hanger bracket. Secure with two screws provided.
9
Install canopy over downrod. Caution: Replace pin and ball onto downrod.
12Safety cable installation
Safety Cable
Lag Screw
For Canadian installation and for USA fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
15
FanHouse
whitewhite
Blackblack orange
blue Green
Make wiring connections as indicated above. White from fan to white from remote marked N. Orange from fan to Orange from remote marked Light/up. Blue from fan to blue from remote marked down light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.
18
