Morphy Richards PerformAir Upright Vacuum manual Using & cleaning the, turbo nozzle, Dust Canister

Models: PerformAir Upright Vacuum

1 8
Download 8 pages 51.43 Kb
Page 5
Image 5
Using & cleaning the

73352 rev2 22/6/06 11:09 Page 5

E

hose connector.

3Add the required accessory to

 

the extension tubes or directly

 

to the tube connector Ï when

 

using the hose and tools.

 

IMPORTANT: Turning the cleaner

 

sideways helps prevent the

 

cleaner being pulled along by

 

the stretch hose.

F

IMPORTANT: Remove the hose

 

connector before returning to

 

floor cleaning with the main

 

nozzle. Push the flap down to

 

disengage the latch before

 

pulling out the connector.

 

Using & cleaning the

 

turbo nozzle

 

(Certain models only)

G

Attach the turbo nozzle to the

tube connector for use on

 

 

upholstery and stairs.

¯

After use your turbo nozzle may

 

 

become clogged. Turn over the

 

nozzle and pull away any hairs

 

or fibres. If they are tightly

 

wound around the brush

 

carefully snip the fibres with

 

scissors, being careful not to

 

damage the brush bar, pull away

 

from the bar and dispose.

H

DUST CANISTER

 

ˆ

Emptying

1 Remove the dust canister from

 

the product by pressing the

 

canister release button E ›.

2Every time the dust canister is

 

emptied, slide the filter cleaning

 

clicker lever F fl several times

 

before emptying (this will agitate

 

the fine dust between the filter

I

pleats and restore the air flow).

 

 

3 Holding the canister over a

 

dustbin press the one touch

 

empty button G ¯ and the

 

bottom of the canister will drop

 

down and release the dirt.

4 Close the bottom of the dust

 

canister by pressing the base

 

upwards until it clicks into place.

 

5 Re-fit dust canister and push

 

back into position.

Allergy sufferers

If the allergy suffer is emptying the product it is recommended that the container is placed into a plastic bag to empty.

1Place the container inside the plastic bag, releasing the container with one hand whilst holding the top of the bag closed with the other, leave the dust to settle for a few seconds before removing the canister. The plastic bag can then be sealed and disposed of.

FILTERS

Using the filter cleaning lever at every emptying will help maintain good suction however for a through clean the dust canister and dust canister filters may be dissembled and washed.

Motor protection filter

The motor protection filter ˆ is located underneath the dust canister. H

1Remove the dust canister. E

2Lift out the filter and shake over a dustbin. The filter may also be washed in water (no detergents) but must be totally dry before re-fitting.

3Replace the filter.

Exhaust filter

The allergy exhaust filter should be replaced every 6 months to maintain the high performance filtration. Call our Replacement Parts Helpline.

The exhaust filter is located below the dust canister compartment.

1Remove the exhaust filter grille.

‰ I

2Remove the exhaust filter Ê by pulling forward at the top and lifting away.

www.morphyrichards.com

 

5

Page 5
Image 5
Morphy Richards PerformAir Upright Vacuum Using & cleaning the, turbo nozzle, Dust Canister, Emptying, Allergy sufferers